News Center
16
2024
-
04
Do a good job in the inspection of the pastoral management machine
In order to make the pastoral management machine normal use, the correct operation method, regular maintenance, but also to do the following inspection work, so that there can be problems found in time, timely treatment:
1. The newly installed wheel hoop is easy to loosen and must be checked frequently.
2. Pay attention to whether the work of each part of the pastoral management machine is normal.
3. Pay attention to check the wear degree of the easy wear parts of the pastoral management machine, and pay attention to replacing the worn parts at any time.
4. Put the bottom frame plane of the movable device, and remove dust and other objects to prevent the movable bearing from moving on the bottom frame when the machine encounters unbroken materials, resulting in serious accidents.
5, bearing oil temperature rise, should immediately stop to check the cause and eliminate.
Therefore, everyone must do a good job of inspection before using the pastoral management machine each time, and notify the maintenance personnel in time if problems are found, so as not to aggravate and affect normal use.
The engine is an important equipment of the micro-tiller. It is a power mechanical equipment that uses diesel or gasoline as fuel. Therefore, we must pay attention to the refueling of the micro-tiller. The details are as follows:
Diesel tank: After the engine is working, the diesel will be heated and expanded, coupled with mechanical vibration. If the fuel tank is overfilled, the diesel will overflow from the fuel tank cap, which is a waste of fuel and easy to cause a fire. Therefore, it is appropriate to add 90% of the tank volume.
Oil pan: When the oil in the oil pan is added too much, the oil will enter the combustion chamber to participate in combustion, which not only increases oil consumption, but also easily causes flying accidents. In addition, too much oil will increase the movement resistance of the connecting rod and crankshaft and increase power loss. Therefore, the oil in the oil pan should be added between the upper and lower engraved lines of the oil dipstick.
Air filter: The oil in the oil pan of the oil-bath air filter should be added to the position of the engraved line. If it is added too much, the oil will be sucked into the cylinder to participate in combustion, which will easily cause carbon deposits and cause speeding accidents.
Cooling water pump bearing: Do not add too much oil in the water pump bearing, otherwise it will increase the frictional resistance of the bearing, and it will also cause premature damage to the water pump and oil seal.
In addition to the above content, but also pay attention to the refueling must not be too full, so as to better use the micro tillage machine, so that it can play a greater work efficiency.
Related News
Contact Information
Address: Da Changyuan Village, Sangyuan Town, Ju County, Rizhao City, Shandong Province
嘉恒智能
SAF Coolest v1.3.1.2 设置面板 YNWSD-ZXVN-PXSVE-XVZ
无数据提示
Sorry, the current column is being updated, please look forward to it!
You can view other columns or returnHome Page